The wizard contains several options for handling VoIP call traffic, shown in Figure 108: Voice over IP . Prioritizing Voice over IP traffic sets up queues and rules to give priority to VoIP calls and related traffic. Thi

Warnings/Precautions

It is best to perform this change from an interface that is not involved, such as a DMZ, OPT port, perhaps WAN or VPN. Though if the switch is properly configured there should be no loss of connectivity, at least with LA

Why would this be done?

To use squid authentication, squid cannot be used in transparent mode. HTTPS traffic also cannot be filtered using transparent mode. When squid is run in normal mode, a proxy IP and port must be configured on each client

WireGuard Settings

WireGuard Tunnel Settings: When creating or editing a WireGuard tunnel, the following options are available: Enabled: Controls whether or not this WireGuard instance is enabled or disabled. Note : A WireGuard instance ca

Configuration Recipes

Subcategories

A Brief Introduction to Web Proxies and Reporting: Squid, SquidGuard, and Lightsquid

Accessing a CPE/Modem from Inside the Firewall

Accessing Port Forwards from Local Networks

Adding OpenVPN Remote Access Users

Allowing Remote Access to the GUI

Authenticating from Active Directory using RADIUS/NPS

Authenticating OpenVPN Users with FreeRADIUS

Authenticating OpenVPN Users with RADIUS via Active Direc- tory

Authenticating Squid Package Users with FreeRADIUS

Authenticating Users with Google Cloud Identity

Basic Firewall Configuration Example

Blocking External Client DNS Queries

Blocking Web Sites

Bridging OpenVPN Connections to Local Networks

Configuring a Single Multi-Purpose OpenVPN Instance

Configuring AZTCO-FW Software for Online Gaming

Configuring BIND as an RFC 2136 Dynamic DNS Server

Configuring DNS over TLS

Configuring IPsec IKEv2 Remote Access VPN Clients

Configuring IPv6 Through A Tunnel Broker Service

Configuring Multi-WAN for IPv6

Configuring NAT for a VoIP PBX

Configuring NAT for VoIP Phones

Configuring Switches with VLANs

Configuring the Squid Package as a Transparent HTTP Proxy

Connecting OpenVPN Sites with Conflicting IP Subnets

Connecting to L2TP/IPsec from Android

Dynamic Routing Protocol Basics

External User Authentication Examples

High Availability Configuration Example with Multi-WAN

High Availability Configuration Example without NAT

High Availability Configuration Example

IKEv2 Server Configuration

Installing OpenVPN Remote Access Clients

IPsec Remote Access VPN Example Using IKEv1 with Pre- Shared Keys

IPsec Remote Access VPN Example Using IKEv1 with Xauth

IPsec Remote Access VPN Example Using IKEv2 with EAP- RADIUS

IPsec Remote Access VPN Example Using IKEv2 with EAP-TLS

IPsec Site-to-Site VPN Example with Pre-Shared Keys

L2TP/IPsec Remote Access VPN Configuration Example

Migrating an Assigned LAN to LAGG

OpenVPN Remote Access Configuration Example

OpenVPN Site-to-Site Configuration Example with Shared Key

OpenVPN Site-to-Site Configuration Example with SSL/TLS

Preventing RFC1918 Traffic from Exiting a WAN Interface

Routing Internet Traffic Through a Site-to-Site IPsec Tunnel

Routing Internet Traffic Through A Site-To-Site OpenVPN Tun- nel

Routing Public IP Addresses

Setting up WPAD Autoconfigure for the Squid Package

Using EAP and PEAP with FreeRADIUS

Using Mobile One-Time Passwords with FreeRADIUS

Using NAT and FTP without a Proxy

Using the Shaper Wizard to Configure ALTQ Traffic Shaping

Articles

Voice over IP

Warnings/Precautions

Why would this be done?

WireGuard Settings

Your privacy. Your choice.