Migrating an Assigned LAN to LAGG

Configuration guides, troubleshooting and practical advice for AZTCOFW.

Articles

4 results

Migrate LAN to a LAGG

Ensure the second NIC for the LAGG is not assigned (e.g. re0 mapped to OPT1 ) In the AZTCO-FW webGUI, check Interfaces > Assignments and remove its entry if present Create a new LAGG including only the second NIC Navigat

Prerequisites/Assumptions

The switch must be properly configured to accommodate the LAGG. This typically means configuring an LACP group and setting ports to use that group. The NICs involved, in this example re0 and re2, should be connected to p

VLANS

If any VLANs were in use directly on the interfaces involved, migrate them as follows: Add new VLAN tags using the LAGG interface as the parent ( Interfaces > Assignments , VLAN tab) Fix the assignments to use the LAGG v

Warnings/Precautions

It is best to perform this change from an interface that is not involved, such as a DMZ, OPT port, perhaps WAN or VPN. Though if the switch is properly configured there should be no loss of connectivity, at least with LA