Troubleshooting Installation Issues

Configuration guides, troubleshooting and practical advice for AZTCOFW.

Articles

4 results

Boot from hard drive after installation fails

After the installation completes and the firewall restarts, there are conditions which may prevent the operating system from fully booting. The most common reasons are typically BIOS-related. For example, a BIOS implemen

Boot from Install Media Fails

Due to the wide array of hardware combinations in use, it is not uncommon for a memstick or CD to boot incorrectly (or not at all). Given the unpredictable nature of commodity hardware support, using hardware from the Ne

Hardware Troubleshooting

the following suggestions will help resolve general hardware issues. Booting from USB If the boot stops with a mountroot> prompt while booting off the installer image, usually with USB CD/DVD drives, escape to the loader

Interface link up not detected

If the firewall complains that it did not detect an interface link up event during automatic assignment, first make sure that the cable is unplugged and that the interface does not have a link light prior to choosing the